5-15
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
To configure the WDS access points using the IOS command line interface:
Step 1
Log in to an access point that will be a WDS device.
Step 2
Turn on AAA services:
aaa new-model
Step 3
Define the RADIUS servers that you will use for infrastructure authentication
and/or client authentication. Consult your RADIUS server documentation for the
correct port numbers. CiscoSecure ACS uses port 1645 for authorization and port
1646 for accounting.
radius-server host [
ip_address | hostname ] auth-port port
acct-port
port key shared_secret_key
Step 4
Define a server group for infrastructure authentication:
aaa group server radius
server_group_name server radius_server
Step 5
Define at least one additional server group for wireless client authentication.
Step 6
Configure the AP to run WDS:
wlccp wds priority
priority interface BVI1
where
priority
is a value from 1 to 255. Priority determines which AP will be the
active WDS AP when multiple APs are configured to run WDS. The highest
priority is 255.
Step 7
Configure the Wireless Network Manager (WNM) component:
wlccp wnm ip address
wlse_ip_address
where
wlse_ip_address
is the address of the WLSE.
Step 8
Configure the server group the WDS will use to LEAP authenticate SWAN
infrastructure access points. Use the server group name that you created in Step 4.
aaa authentication login
named_authentication_list group
server_group_name
wlccp authentication-server infrastructure
named_authentication_list
