5-23
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
Using the Web-based Interface to Validate the Configuration
To confirm the configurations using the web-based interface on WDS APs:
Step 1
Log in to the web interface on each
active
WDS AP.
Step 2
Select
Wireless Services > WDS > WDS Status
.
Check for the following:
•
The WDS Information section should display the device WDS state as
ACTIVE.
•
The WDS Registration and AP Information sections should show the correct
number of APs (all of the infrastructure APs and the WDS AP).
•
The Mobile Node Information section should display the wireless clients
participating in SWAN.
•
The Wireless Network Manager section should contain the WLSE IP address.
If the WLSE authentication status is SECURITY KEYS SETUP, the WLSE
is properly registered.
Using the Command-Line Interface to Validate the Configuration
To use the CLI on the WDS APs to validate the configuration:
Step 1
Log in to the CLI on each
active
WDS AP.
Step 2
To validate the WDS configuration, enter:
show wlccp wds ap
This command lists all of the infrastructure APs and the WDS AP.
Step 3
To verify that the WLSE is correctly registered, enter:
show wlccp wnm status
This command should display the WLSE IP address. If the WLSE authentication
status is SECURITY KEYS SETUP, the WLSE is properly registered.
