29-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 29 Configuring LLDP, LLDP-MED, and Wired Location Service
Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
Note
Your switch must be running the cryptographic (encrypted) software image to enable the
nmsp
global
configuration commands.
This example shows how to enable NMSP on a switch and to set the location notification time to 10
seconds:
Switch(config)#
nmsp enable
Switch
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
To monitor and maintain LLDP, LLDP-MED, and wired location service on your device, perform one
or more of these tasks, beginning in privileged EXEC mode.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
nmsp
enable
Enable the NMSP features on the switch.
Step 3
nmsp notification interval
{
attachment
|
location
}
interval-seconds
Specify the NMSP notification interval.
attachment
—Specify the attachment notification interval.
location—
Specify the location notification interval.
interval-seconds—
Duration in seconds before the switch sends the
MSE the location or attachment updates. The range is 1 to 30; the
default is 30.
Step 4
end
Return to privileged EXEC mode.
Step 5
show network-policy profile
Verify the configuration.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Description
clear lldp counters
Reset the traffic counters to zero.
clear lldp table
Delete the LLDP neighbor information table.
clear nmsp statistics
Clear the NMSP statistic counters.
show lldp
Display global information, such as frequency of transmissions, the holdtime for
packets being sent, and the delay time before LLDP initializes on an interface.
show lldp entry
entry-name
Display information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the
neighbor name.
show lldp interface
[
interface-id
]
Display information about interfaces with LLDP enabled.
You can limit the display to a specific interface.
