B-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Configuration Files
Guidelines for Creating and Using Configuration Files
Creating configuration files can aid in your switch configuration. Configuration files can contain some
or all of the commands needed to configure one or more switches. For example, you might want to
download the same configuration file to several switches that have the same hardware configuration.
Use these guidelines when creating a configuration file:
•
We recommend that you connect through the console port or Ethernet management port for the
initial configuration of the switch. If you are accessing the switch through a network connection
instead of through a direct connection to the console port or Ethernet management port, keep in mind
that some configuration changes (such as changing the switch IP address or disabling ports) can
cause a loss of connectivity to the switch.
•
If no password has been set on the switch, we recommend that you set one by using the
enable secret
secret-password
global configuration command.
Note
The
copy
{
ftp: | rcp: | tftp:
}
system:running-config
privileged EXEC command loads the
configuration files on the switch as if you were entering the commands at the command line. The switch
does not erase the existing running configuration before adding the commands. If a command in the
copied configuration file replaces a command in the existing configuration file, the existing command
is erased. For example, if the copied configuration file contains a different IP address in a particular
command than the existing configuration, the IP address in the copied configuration is used. However,
some commands in the existing configuration might not be replaced or negated. In this case, the resulting
configuration file is a mixture of the existing configuration file and the copied configuration file, with
the copied configuration file having precedence.
To restore a configuration file to an exact copy of a file stored on a server, copy the configuration file
directly to the startup configuration (by using the
copy
{
ftp: | rcp: | tftp:
}
nvram:startup-config
privileged EXEC command), and reload the switch.
Configuration File Types and Location
Startup configuration files are used during system startup to configure the software. Running
configuration files contain the current configuration of the software. The two configuration files can be
different. For example, you might want to change the configuration for a short time period rather than
permanently. In this case, you would change the running configuration but not save the configuration by
using the
copy running-config startup-config
privileged EXEC command.
The running configuration is saved in DRAM; the startup configuration is stored in the NVRAM section
of flash memory.
