38-62
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 38 Configuring IP Unicast Routing
Configuring BGP
To disable an existing BGP neighbor or neighbor peer group, use the
neighbor
shutdown
router
configuration command. To enable a previously existing neighbor or neighbor peer group that had been
disabled, use the
no neighbor shutdown
router configuration command.
Step 11
neighbor
{
ip-address
|
peer-group-name
}
local-as
number
(Optional) Specify an autonomous-system number to use as the
local autonomous system. The range is 1 to 65535.
Step 12
neighbor
{
ip-address
|
peer-group-name
}
advertisement-interval
seconds
(Optional) Set the minimum interval between sending BGP
routing updates.
Step 13
neighbor
{
ip-address
|
peer-group-name
}
maximum-prefix
maximum
[
threshold
]
(Optional) Control how many prefixes can be received from a
neighbor. The range is 1 to 4294967295. The
threshold
(optional) is the percentage of the maximum at which a warning
message is generated. The default is 75 percent.
Step 14
neighbor
{
ip-address
|
peer-group-name
}
next-hop-self
(Optional) Disable next-hop processing on the BGP updates to a
neighbor.
Step 15
neighbor
{
ip-address
|
peer-group-name
}
password
string
(Optional) Set MD5 authentication on a TCP connection to a
BGP peer. The same password must be configured on both BGP
peers, or the connection between them is not made.
Step 16
neighbor
{
ip-address
|
peer-group-name
}
route-map
map-name
{
in
|
out
}
(Optional) Apply a route map to incoming or outgoing routes.
Step 17
neighbor
{
ip-address
|
peer-group-name
}
send-community
(Optional) Specify that the COMMUNITIES attribute is sent to
the neighbor at this IP address.
Step 18
neighbor
{
ip-address
|
peer-group-name
}
timers
keepalive holdtime
(Optional) Set timers for the neighbor or peer group.
•
The
keepalive
interval is the time within which keepalive
messages are sent to peers. The range is 1 to 4294967295
seconds; the default is 60.
•
The
holdtime
is the interval after which a peer is declared
inactive after not receiving a keepalive message from it. The
range is 1 to 4294967295 seconds; the default is 180.
Step 19
neighbor
{
ip-address
|
peer-group-name
}
weight
weight
(Optional) Specify a weight for all routes from a neighbor.
Step 20
neighbor
{
ip-address
|
peer-group-name
}
distribute-list
{
access-list-number
|
name
} {
in
|
out
}
(Optional) Filter BGP routing updates to or from neighbors, as
specified in an access list.
Step 21
neighbor
{
ip-address
|
peer-group-name
}
filter-list
access-list-number
{
in
|
out
|
weight
weight
}
(Optional) Establish a BGP filter.
Step 22
neighbor
{
ip-address
|
peer-group-name
}
version
value
(Optional) Specify the BGP version to use when communicating
with a neighbor.
Step 23
neighbor
{
ip-address
|
peer-group-name
}
soft-reconfiguration inbound
(Optional) Configure the software to store received updates.
Step 24
end
Return to privileged EXEC mode.
Step 25
show ip bgp neighbors
Verify the configuration.
Step 26
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
