Cisco Catalyst 3130, Руководство по настройке программного обеспечения

Страница: 1207 / 1354

46-11
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 46 Configuring Fallback Bridging
Monitoring and Maintaining Fallback Bridging
This example shows how to disable spanning tree on a port in bridge group 10:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# bridge group 10 spanning-disabled
Monitoring and Maintaining Fallback Bridging
To monitor and maintain the network, use one or more of the privileged EXEC commands in Table 46-2 :
To display the bridge-group MAC address table on a stack member, start a session from the stack master
to the stack member by using the
session stack-member-number global configuration command. Enter
the show bridge [ bridge-group ] [ interface-id | mac-address | verbose ] privileged EXEC command at
the stack member prompt.
For information about the fields in these displays, see the Cisco IOS Bridging and IBM Networking
Command Reference, Volume 1 of 2, Release 12.2.
Table 46-2 Commands for Monitoring and Maintaining Fallback Bridging
Command Purpose
clear bridge bridge-group Removes any learned entries from the forwarding
database.
show bridge [ bridge-group ] group Displays details about the bridge group.
show bridge [ bridge-group ] [ interface-id |
mac-address | verbose ]
Displays MAC addresses learned in the bridge group.