33-3
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 33 Configuring Embedded Event Manager
Understanding Embedded Event Manager
•
IOS CLI event detector– Generates policies based on the commands entered through the CLI.
•
Generic Online Diagnostics (GOLD) event detector– Publishes an event when a GOLD failure event
is detected on a specified card and subcard.
•
Counter event detector–Publishes an event when a named counter crosses a specified threshold.
•
Interface counter event detector– Publishes an event when a generic Cisco IOS interface counter for
a specified interface crosses a defined threshold. A threshold can be specified as an absolute value
or an incremental value.For example, if the incremental value is set to 50 an event would be
published when the interface counter increases by 50.
This detector also publishes an event about an interface based on the rate of change for the entry and
exit values.
•
None event detector– Publishes an event when the
event manager run
CLI command executes an
EEM policy. EEM schedules and runs policies on the basis on an event specification within the
policy itself. An EEM policy must be manually identified and registered before the
event manager
run
command executes.
•
Online insertion and removal event detector–Publishes an event when a hardware insertion or
removal (OIR) event occurs.
•
Remote procedure call (RPC) event detector—Invokes EEM policies from outside the switch over
an encrypted connecting using Secure Shell (SSH) and uses Simple Object Access Protocol (SOAP)
data encoding for exchanging XML-based messages. It also runs EEM policies and then gets the
output in a SOAP XML-formatted reply.
•
SNMP event detector– Allows a standard SNMP MIB object to be monitored and an event to be
generated when
–
The object matches specified values or crosses specified thresholds.
–
The SNMP delta value, the difference between the monitored Object Identifier (OID) value at
the beginning the period and the actual OID value when the event is published, matches a
specified value.
•
SNMP notification event detector—Intercepts SNMP trap and inform messages received by the
switch. The event is generated when an incoming message matches a specified value or crosses a
defined threshold.
•
Syslog event detector– Allows for screening syslog messages for a regular expression pattern match.
The selected messages can be further qualified, requiring that a specific number of occurrences be
logged within a specified time. A match on a specified event criteria triggers a configured policy
action.
•
Timer event detector— Publishes events for
–
An absolute-time-of-day timer publishes an event when a specified absolute date and time
occurs.
–
A countdown timer publishes an event when a timer counts down to zero.
–
A watchdog timer publishes an event when a timer counts down to zero. The timer automatically
resets itself to its initial value and starts to count down again.
–
A CRON timer publishes an event by using a UNIX standard CRON specification to define
when the event is to be published. A CRON timer never publishes events more than once per
minute.
•
Watchdog event detector (IOSWDSysMon)—Publishes an event only on the master switch when
–
CPU utilization for a Cisco IOS process crosses a threshold.
–
Memory utilization for a Cisco IOS process crosses a threshold.
