41-9
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 41 Configuring Cisco IOS IP SLAs Operations
Configuring IP SLAs Operations
Step 3
udp-jitter
{
destination-ip-address
|
destination-hostname
}
destination-port
[
source-ip
{
ip-address
|
hostname
}]
[
source-port
port-number
]
[
control
{
enable
|
disable
}]
[
num-packets
number-of-packets
]
[
interval
interpacket-interval
]
Configure the IP SLAs operation as a UDP jitter operation, and enter UDP
jitter configuration mode.
•
destination-ip-address
|
destination-hostname
—Specify the destination IP
address or hostname.
•
destination-port
—Specify the destination port number in the range from 1
to 65535.
•
(Optional)
source-ip
{
ip-address
|
hostname
}
—
Specify the source IP
address or hostname. When a source IP address or hostname is not
specified, IP SLAs chooses the IP address nearest to the destination
•
(Optional)
source-port
port-number
—Specify the source port number in
the range from 1 to 65535. When a port number is not specified, IP SLAs
chooses an available port.
•
(Optional)
control
—Enable or disable sending of IP SLAs control
messages to the IP SLAs responder. By default, IP SLAs control messages
are sent to the destination device to establish a connection with the IP
SLAs responder
•
(Optional)
num-packets
number-of-packets
—Enter the number of
packets to be generated. The range is 1 to 6000; the default is 10.
•
(Optional)
interval
inter-packet-interval
—Enter the interval between
sending packets in milliseconds. The range is 1 to 6000; the default value
is 20 ms.
Step 4
frequency
seconds
(Optional) Set the rate at which a specified IP SLAs operation repeats. The
range is from 1 to 604800 seconds; the default is 60 seconds.
Step 5
exit
Exit UDP jitter configuration mode, and return to global configuration mode.
Step 6
ip sla monitor schedule
operation-number
[
life
{
forever
|
seconds
}] [
start-time
{
hh
:
mm
[:
ss
]
[
month day
|
day month
] |
pending
|
now
|
after
hh:mm:ss
] [
ageout
seconds
] [
recurring
]
Configure the scheduling parameters for an individual IP SLAs operation.
•
operation-number
—Enter the RTR entry number.
•
(Optional)
life
—Set the operation to run indefinitely (
forever
) or for a
specific number of
seconds
. The range is from 0 to 2147483647. The
default is 3600 seconds (1 hour).
•
(Optional)
start-time
—Enter the time for the operation to begin collecting
information:
–
To start at a specific time, enter the hour, minute, second (in 24-hour
notation), and day of the month. If no month is entered, the default is
the current month.
–
Enter
pending
to select no information collection until a start time is
selected.
–
Enter
now
to start the operation immediately.
–
Enter
after
hh:mm:ss
to show that the operation should start after the
entered time has elapsed.
•
(Optional)
ageout
seconds
—Enter the number of seconds to keep the
operation in memory when it is not actively collecting information. The
range is 0 to 2073600 seconds, the default is 0 seconds (never ages out).
•
(Optional)
recurring
—Set the operation to automatically run every day.
Command
Purpose
