Cisco Catalyst 2960 Series, Руководство по настройке

Страница: 783 / 2288

Purpose Command or Action
(Optional) Filters out DHCPv6 replies and DHCPv6 advertisements
on the port that are not from a device of the specified role. Default
is
client .
[ no ] device-role { client | server }
Example:
Switch(config-dhcp-guard)# device-role server
Step 3
•
client
—
Default value, specifies that the attached device is a
client. Server messages are dropped on this port.
• server — Specifies that the attached device is a DHCPv6 server.
Server messages are allowed on this port.
(Optional). Enables verification that the advertised DHCPv6 server
or relay address is from an authorized server access list (The [
no
]
match server access-list ipv6-access-list-name
Example:
;;Assume a preconfigured IPv6 Access List
Step 4
destination address in the access list is 'any'). If not configured, this
check will be bypassed. An empty access list is treated as a permit
all.
as follows:
Switch(config)#
ipv6 access-list my_acls
Switch(config-ipv6-acl)# permit host
FE80::A8BB:CCFF:FE01:F700 any
;;configure DCHPv6 Guard to match approved
access list.
Switch(config-dhcp-guard)#
match server
access-list my_acls
(Optional) Enables verification of the advertised prefixes in DHCPv6
reply messages from the configured authorized prefix list. If not [ no ] match reply prefix-list ipv6-prefix-list-name
Example:
;;Assume a preconfigured IPv6 prefix list
Step 5
configured, this check will be bypassed. An empty prefix list is
treated as a permit.
as follows:
Switch(config)#
ipv6 prefix-list my_prefix
permit 2001:0DB8::/64 le 128
;; Configure DCHPv6 Guard to match prefix
Switch(config-dhcp-guard)#
match reply
prefix-list my_prefix
Configure max and min when device-role is server to filter DCHPv6
server advertisements by the server preference value. The defaults
permit all advertisements.
[ no ] preference { max limit | min limit }
Example:
Switch(config-dhcp-guard)# preference max
250
Switch(config-dhcp-guard)#
preference min 150
Step 6
max limit — (0 to 255) (Optional) Enables verification that the
advertised preference (in preference option) is less than the specified
limit. Default is 255. If not specified, this check will be bypassed.
min limit — (0 to 255) (Optional) Enables verification that the
advertised preference (in preference option) is greater than the
specified limit. Default is 0. If not specified, this check will be
bypassed.
(Optional)
trusted-port
— Sets the port to a trusted mode. No further
policing takes place on the port.
[ no ] trusted-port
Example:
Switch(config-dhcp-guard)# trusted-port
Step 7
If you configure a trusted port then the device-role option
is not available.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
701
How to Configure an IPv6 DHCP Guard Policy