Cisco Catalyst 2960 Series, Руководство по настройке

Страница: 1331 / 2288

DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if prompted. enable
Example:
Switch> enable
Step 1
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Defines an extended MAC access list using a name. mac access-list extended name
Example:
Switch(config)# mac access-list extended mac1
Step 3
In extended MAC access-list configuration mode, specifies to
permit
or
deny
any source MAC address, a source MAC address
{
deny
|
permit
} {
any
|
host source MAC address
|
source MAC address mask } { any | host destination
Step 4
with a mask, or a specific host source MAC address and any MAC address | destination MAC address mask } [ type
destination MAC address, destination MAC address with a mask,
or a specific destination MAC address. mask | lsap lsap mask | aarp | amber | dec-spanning
| decnet-iv | diagnostic | dsm | etype-6000 |
etype-8042 | lat | lavc-sca | mop-console |
(Optional) You can also enter these options:
mop-dump | msdos | mumps | netbios | vines-echo
|
vines-ip
|
xns-idp
| 0 -65535 ] [
cos cos
] • type mask — An arbitrary EtherType number of a packet with
Ethernet II or SNAP encapsulation in decimal, hexadecimal,
Example:
Switch(config-ext-macl)# deny any any
or octal with optional mask of don
’
t care bits applied to the
EtherType before testing for a match.
•
lsap lsap mask
—
An LSAP number of a packet with
IEEE 802.2 encapsulation in decimal, hexadecimal, or octal
with optional mask of
don
’
t care bits.
decnet-iv
or
Switch(config-ext-macl)#
permit any any •
aarp
|
amber
|
dec-spanning
|
decnet-iv
|
diagnostic
|
dsm
| etype-6000 | etype-8042 | lat | lavc-sca | mop-console |
mop-dump | msdos | mumps | netbios | vines-echo | vines-ip
|
xns-idp
— A non-IP protocol.
•
cos cos
—
An IEEE 802.1Q cost of service number from 0 to
7 used to set priority.
Returns to privileged EXEC mode. end
Example:
Switch(config-ext-macl)# end
Step 5
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1249
How to Configure VLAN Access Control Lists