Cisco Catalyst 2960 Series, Руководство по настройке

Страница: 612 / 2288

DETAILED STEPS
Purpose Command or Action
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 1
Enters interface configuration mode and configures an interface. interface type
Step 2
Example:
Switch(config)# interface
Command parameters for the interface configuration include:
You cannot attach a NetFlow monitor to a port channel interface. If both
service module interfaces are part of an EtherChannel, you should attach
the monitor to both physical interfaces.
GigabitEthernet1/0/1
Associate an IPv4 or an IPv6 flow monitor, and an optional sampler to
the interface for input or output packets. {
ip flow monitor
|
ipv6 flow monitor
} name
[| sampler name ] { input | output }
Step 3
Example:
Switch(config-if)#
ip flow monitor
To monitor datalink L2 traffic flows, you would use datalink flow
monitor name sampler sampler-name { input } interface command. This
specific command associates a datalink L2 flow monitor and required
sampler to the interface for input packets. When a datalink flow monitor
MonitorTest input
is assigned to an interface or VLAN record, it only creates flows for
non-IPv6 or non-IPv4 traffic.
Whenever you assign a flow monitor to an interface, you must
configure a sampler. If the sampler is missing, you will receive
an error message. Note
Returns to privileged EXEC mode.
end
Example:
Switch(config-flow-monitor)# end
Step 4
(Optional) Displays information about NetFlow on an interface. show flow interface [ interface-type number ] Step 5
Example:
Switch# show flow interface
(Optional) Saves your entries in the configuration file.
copy running-config startup-config
Step 6
Example:
Switch# copy running-config
startup-config
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
530
How to Configure NetFlow Lite