Cisco 2975 - Catalyst LAN Base Switch, Руководство по настройке программного обеспечения

Страница: 154 / 982

6-24
Catalyst 2975 Switch Software Configuration Guide
OL-19720-02
Chapter 6 Managing Switch Stacks
Troubleshooting Stacks
Caution
Powering on Switch 4 before enabling the Port 1 on Switch 1 might cause one of the switches to reload.
If Switch 4 is powered on first, you might need to enter the switch 1 stack port 1 enable and the switch
4 stack port 2 enable privileged EXEC commands to bring up the link.
Understanding the show switch stack-ports summary Output
Only Port 1 on stack member 2 is disabled.
Switch# show switch stack-ports summary
Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 OK 3 50 cm Yes Yes Yes 1 No
1/2 Down None 3 m Yes No Yes 1 No
2/1 Down None 3 m Yes No Yes 1 No
2/2 OK 3 50 cm Yes Yes Yes 1 No
3/1 OK 2 50 cm Yes Yes Yes 1 No
3/2 OK 1 50 cm Yes Yes Yes 1 No
Table 6-5 show switch stack-ports summary Command Output
Field Description
Switch#/Port# Member number and its stack port number.
Stack Port Status • Absent—No cable is detected on the stack port.
•
Down—A cable is detected, but either no connected neighbor is up,
or the stack port is disabled.
• OK—A cable is detected, and the connected neighbor is up.
Neighbor Switch number of the active member at the other end of the stack cable.
Cable Length Valid lengths are 50 cm, 1 m, or 3 m.
If the switch cannot detect the cable length, the value is no cable . The
cable might not be connected, or the link might be unreliable.
Link OK This shows if the link is stable.
The link partner is a stack port on a neighbor switch.
•
No—The link partner receives invalid protocol messages from the
port.
• Yes—The link partner receives valid protocol messages from the
port.
Link Active This shows if the stack port is in the same state as its link partner.
•
No—The port cannot send traffic to the link partner.
• Yes—The port can send traffic to the link partner.
Sync OK
•
No—The link partner does not send valid protocol messages to the
stack port.
• Yes—The link partner sends valid protocol messages to the port.