9�2�4�- BAT
On this tab,
Figure 87
, you can do the following:
Figure 87: Basic setup (Bat)
Full battery charging
You can fully charge the battery manually by pressing the
Start
key.
During charging, the screen displays the status of the process and, once finished, the
Cirpower
Hyb
returns to the automatically defined operating mode.
Battery calibration
It is possible to activate the battery calibration process so that you can check its energy storage
capacity.
Note:
The battery does not have to be calibrated if it has its own BMS and a communication
system to communicate with
Cirpower Hyb.
Make sure that the battery can inject power into the grid and that charging it from
the grid does not cause installation problems before calibrating the batteries.
The calibration process will force the full discharge of the battery into the grid and
its subsequent full charging, for which it can consume energy from the grid
Press the
Start
key to start the calibration process.
The screen shown in
Figure 78
will be displayed while the battery is being calibrated.
88
CirPower Hyb 4k-48
Instruction Manual
