7�1�8�3�- Installation without a battery
Table 9: Standby modes (Type of installation: Without battery)�
Energy
management
strategy
(1)
START/STOP
keys
Type of installation
Direct
loads
(2)
AC
Grid
Solar Battery
Standby Mode
Off 1
-
No
Yes
-
No
Off 2
-
-
No
No
Night
-
No
Yes
(1)
See
7.2.1.- ENERGY MANAGEMENT STRATEGIES
(2)
If a battery is not used, direct charging from an AC output is not required.
7�1�8�3�1�- Off 1 mode
If the
key is in the position
for more than 30 minutes, the inverter will be set
to the standby mode.
The purpose of this standby mode is to prevent unnecessary consumption from the AC network.
Note:
In these modes, the power supply of the device is disconnected and the
only way to start the
inverter
again is by pressing the ON/OFF switch on the display.
The system cannot establish the remote connection
to the device.
7�1�8�3�2�- Off 2 Mode
With devices that do not have new batteries, if the AC network is not available, the device will
be stopped instantaneously due to the lack of electric supply.
The device will be switched on again after the AC network voltage is reconnected.
Note:
The system cannot establish the remote connection
to the device.
7�1�8�3�3�- Night Mode
Devices that do not use batteries do not have to be on during the night if they are not performing
main functions, thus avoiding any unnecessary consumption from the AC network.
Note:
In this mode, the power supply of the unit is disconnected and the
only way to start the invert-
er
again is by pressing the ON/OFF switch on the display.
You can start the decive by holding down the ON/OFF switch on the display for 3 seconds. The
device will be turned off again if the system conditions remain unchanged for 10 minutes.
It will be switched on again on the next morning.
The system cannot establish the remote connection
to the device.
54
CirPower Hyb 4k-48
Instruction Manual
