OPERATOR MANUAL
6.
Initial setting
58
6.3
Embossing pressure adjustment
The machine is configured by the constructor in
the final testing phase for the production of
alluminium plates of thickness 0.5mm.
For steel plates or for plates of greater thickness it
is necessary to increase the embossing pressure
and this is done as follows:
•
Lift the front cover, to adjustment knob is
locateded in the center of the machine above
the drim (Ref. Fig. 5.6). In order to increase
the embossing pressure it is necessary to
loosen the nut (1) which blocks the knob (2).
This is done with a 13mm wrenc. Next
observing the notches an the knob turn the
knob a few degrees in a clockwise direction.
Now tighten the nut. To diminish the pressure
one reversed this process turning the knob in
the anti-clockwise direction.
•
Once the pressure has been adjusted it is
advisable to emboss a plate in order to control
that the result is perfectly even. If this not the
case one should repeat the operation until the
desired result is obtained.
An inappropriate adjustment can compromise the
general working of the embosser.
It is advisable to have this adjustment done by a
qualified person or by the Technical Assistance.
