OPERATOR MANUAL
4.
Installation
21
4.3
Electrical connection
The installation of the embosser
ME2000s
can be easily carried out by accessing the various connections
plugs, located on the rear panel.
BACK PANEL
1.
SOCKET PA 80 FOR MAIN CABLE
2.
POWER SWITCH AND FUSE
3.
VENTILATION FILTER GRIDS
4.
USB PLUG TYPE B
5.
USB PLUG TYPE A
6.
ETHERNET PLUG
7.
COVER DISABLE KEY
Proceed as indicated below:
•
Connect the USB TYPE B cable (Optional) between the Computer and the Embosser in case you
use the embosser in ON-LINE mode.
•
Check that the main AC Voltage corresponds to the value indicated in the plate.
Before proceeding, note down the information contained in the paragraph “WARNINGS AND
INSTALLATION PRECAUTIONS”
•
Connect the power cable. Be sure that cable socket is easily accessible.
4.4
Connection to a computer
The ME2000s can be supplied with a 2 m long cable (optional) for USB connection.
If this length is not enough, it is necessary to use an extension cable not longer than 15 meters,
respecting the corresponding connections
CAUTION:
THE SERIAL CABLE MUST BE CONNECTED ONLY WHEN THE MACHINE IS
OFF.
CAUTION:
CONNECT ONLY TO SYSTEMS PROVIDED WITH GROUNDING CIRCUIT
COMPLIANT WITH THE NATIONAL SYSTEM REGULATIONS
