OPERATOR MANUAL
6.
Initial setting
55
6.
Initial setting
Before to start with the production it need to adjust the internal devices to the plates sizes to product.
The quality and quantity of the produced plates depend on the correct adjusting of the mechanical
units:
•
Loader
•
Unloader
•
Embosser
Open the front panel (after input the key supplied) the METAL EMBOSSER as shown in figure below.
1.
PLATES LOADER
2.
PUNCH DEVICES
3.
PLATES UNLOADER
The machine should be switched off and the power supply should be disconnected when it is necessary
to access any of the internal parts of the machine. The safety protection devices have been constructed
to block the machine cycle during that adjustment phase if the preceding standards are not respected.
