OPERATOR MANUAL
6.
Initial setting
56
6.1
Loader adjustment
The Loader unit for the metallic plates (fig. 5.2) is
located on the right side of the Embosser and can
be adjusted to the dimensions of the plates.
To adjust the Loader do as follows:
•
Open the front cover.
•
Loosen the black knobs (1) on the right
side of the Loader.
•
Bring the right support closer to the plate
to be embossed leaving a tolerance of
about 1mm and then tighten the knobs.
•
Loosen the wings knobs (1) of the rear
supports (2), slide them to a distance of
about 5mm from the plate and tighten the
knobs.
•
Loosen the four knobs (3) to adjust the
plate thickness, pull the plate towards the
outside, set the supports 0.5mm higher
and tighten the knobs
