China Electronics Technology Instruments AV3672 Series, Руководство пользователя

Страница: 309 / 424

10 Fault Diagnoses and Repair
10.3 Error Information
305
1870 Error
Measurement is not selected.
Measurement is not selected.
1871 Error
The channel number is beyond the range.
The specified channel number is beyond the allowed range.
1872 Error The channel is not found.
An unknown channel is specified under the program control.
1873 Error The proposed sweep segment is not found.
An unknown sweep segment is specified under the program control.
1874 Error The sweep segment table is empty.
At least one segment should be defined in the segment table sweep mode. This error
only occurs in remote control.
1875 Error
The number of sweep points of the active sweep segment table is 0.
At least one sweep point with segment should be set in the segment table sweepmode.
This error only occurs in remote control.
1876 Error The specified source attenuation is invalid.
Try to set channel attenuation properties to the vector network analyzer with no
source attenuator.
1877 Error There are too many sweep points and the logarithmic sweep mode fails. Reduce
the number of sweep points.
The maximum number of sweep points should be 401 in the logarithmic sweep mode.
1878 Error The set point number is larger than the allowable number in the logarithmic
sweep mode.
The maximum number of sweep points should be 401 in the logarithmic sweep mode.
2048 Error
Options should be added based on the standard analyzer so as to enable this
function.
2049 Error The current measurement instrument does not have the function you need.
2050 Error A conflict occurs between the required function and current instrument state.
2051 Prompt The file <x> has been saved.
2052 Error File <x> saving fails.
2053 Error File opening fails or the file <x> is not found.
2054 Error The <x> head is wrong.
2055 Error The state file is invalid and cannot loaded!
2056 Error Put forward the request to enter the sleep mode.
2057 Error Wake up from the sleep mode. The PBT_APMRESUMEAUTOMATIC message
is received.
2058 Error
Wake up from the standby state. The PBT_APMRESUMESUSPEND message is
received.
2059 Warning
Wake up from the standby state. The PBT_APMRESUMECRITICAL message
is received.
2060 Warning Wake up from the unknown sleep mode. The NOPBT_Message message is
received in allocation and trial recovery.
2061 Error The file <x> already exists. The file is overridden.
Only in remote application.
2063 Error The file <x> has been restored.
Only in remote application.
2064 Error The <x> version is older than the current version.
Try to restore an invalid file.
2065 Error
The <x> version is newer than the current version.