Challenge Titan 265, Инструкция по эксплуатации

Страница: 45 / 88

8.0 Maintenance Guide
44
Message Description Test
Memory Failed A memory error occurred during
test
Encoder wires 9 & 10 are
reversed Should only occur during initial
assembly otherwise is an
encoder error Replace encoder
Memory Locked Tried to change a locked
channel
Next Channel Locked Tried to link two channels
together and the linked channel
is locked
Number Outside of Limit Selected cut position beyond
limits of machine Operator error; false clamp limit
Positioning Error Backgauge failed to move to
programmed position /-
.oo5 Mechanical bind; encoder
failure; main pcboard;
leadscrew thrust washers loose;
gibs loose
Result is Negative When a math operation yields a
negative number
Send Cancelled Console key was pressed while
backgauge was moving Operator error; key board
failure
Sequence Error Timing error in either up or
down cycled Low main pressure; any
sequence valve
Sharpen Knife Sharpen knife alarm Have knife sharpened
Shorted Key Error Console Key shorted Operator error; defective
keyboard
** If error codes cannot be reset by depressing the clear key, the power will have to be turned OFF
and ON**
8.3 Sensor Data Abbreviations
Abbreviations Standby Description Location
RHSAFE 0 Right Safety Switch Inside right of front cover
LHSAFE 0 Left Safety Switch Inside left of front cover
KNFLAT 0 Knife Latch Proximity Switch Left side of cutter opening
HYDLAT *1 Hydraulic Latch Relay Main pcb board
KNFDWN 1 Knife Down Proximity Switch Inside of cutter opening,
right side
PRESET 1 Preset Sensor Rear of cutter, under left
side of table
CUTSOL 0 Cut Valve Solenoid Valve on left side
of manifold
UNLOAD 0 Unload Valve Solenoid Valve* (not in use
yet)
KNLATSOL 0 Knife Latch Solenoid Inside of cutter opening,
left side
CLAMPUP 1 Clamp up Proximity Switch Inside rear of cutter
opening, left side
HYDUP 1 Hyd. Clamp Up Proximity At bottom of clamp
cylinder
KNFUP 0 Knife Up Proximity Switch Inside of cutter opening,
left side
CUTBTN 0 Cut Button On display console