Challenge Titan 265, Инструкция по эксплуатации

Страница: 24 / 88

6.0 Operation
23
6.8 Display Panel
6.9 Definition of Keys
6.9.1 Variable Speed Pinpoint Backgauge Control
The backgauge control is used to manually position the backgauge. The speed of the backgauge will
depend upon where the actuator is pressed. Press farther from center for a faster speed. Press
toward the operator for forward direction and away from the operator for reverse direction.
6.9.2 IN/MM Key
This key toggles the display to show the position and programmed send values in inches (e.g. 5.250),
inch fractions to the nearest 1/64” (e.g. 5_
1 /
4
), or millimeters (e.g. 133.3).
6.9.3 Send Key
The SEND key is used to send the backgauge to any valid position. If an attempt is made to send the
backgauge to an illegal position, an error message will be displayed at the bottom of the screen
stating “Number outside limit”. In the Job mode, the SEND key will also advance the backgauge to
the next sequential cut position before performing the cut.
Display
Cut
Button
Priority Add
(X/Y) Key
ENTER Key
SEND Key IN/MM Key
Variable Speed
Pinpoint Backgauge
Control
Soft
Keys
CLEAR Key
Push-Out Key
Arrow Keys