Challenge Titan 265, Инструкция по эксплуатации

Страница: 51 / 88

8.0 Maintenance Guide
50
4. Back off the adjusting screw on the side that the trim occurred and tighten the other.
5. With the squaring screws tight, make another test. Continue to adjust and test until no trim
occurs when testing in either sequence.
6. Tighten the jam nuts and lock screw.
NOTE: Once the backgauge is square, restore power to the machine and check the backgauge
accuracy (see the Accuracy Adjust section on page 27) to make sure it is accurate.
8.7.3 Clamp Height and Level Adjustment
The clamp height and level need not be adjusted on a new machine setup. If the bottom edge of the
clamp does not measure 4” without false clamp plate (3-3/4” with false clamp plate) from the table
surface on each end of the clamp, then it should be adjusted for optimal cutting performance.
Clamp Height Adjustment Procedure:
1. Make sure clamp and knife are in the up position. Turn the machine off and lock out power,
page 6.
2. Remove the bottom front cover and the top rear cover.
3. Loosen one end of the rack & pinion shaft coupling from the rear of the machine (Figure 30).
Figure 30
4. Loosen the bottom nut at the bottom end of each clamp pull down tie rod (Figure 31 on page
51).
5. Adjust the top nut at the bottom end of each clamp pull down tie rod until a 4” (3-3/4” if false
clamp plate installed) height is measured at each end of the clamp.
6. Tighten each bottom nut at the bottom end of pull down rods.
7. Tighten the rack & pinion shaft coupling.