Challenge Titan 265, Инструкция по эксплуатации

Страница: 16 / 88

5.0 Installation & Setup
15
Figure 8
Then open the top hood and remove one set of hinge screws (Figure 9). Slide the front guard out of
the other hinge.
Figure 9
5.8 Reattaching the Table
Set the table in position, and start its front two mounting screws. Then start the rear two mounting
screws. Replace the two taper pins (must be snug to seat the table), and then tighten all four screws.
Attach the right and left side guides then re-adjust the left hand side guide support screw until it
contacts the side guide and tighten the jam nut. (Figure 6
& Figure 7 on page 14), the preset board
assembly (Figure 5 on page 13), the motor and encoder wire (Figure 4 on page 13) and all guards
and panels.
Once the table is installed, the backgauge squareness and accuracy must be readjusted (see the
Accuracy Adjust section on page 27 and the Squaring the Backguage section on page 49).
5.9 Installing Extension Tables
NOTE : The power should be connected to the machine before installing the table extensions, see the
Power Hook-Up section on page 17.
Using the wood screws provided, attach a back plate to each extension table. Using (4) 3/8-16
capscrews, attach the table support to the under side of the main table as shown in Figure 10 on
page 16. If the machine is equipped with 2-hand cut buttons, route each cut button wire through the
slots in the bracket while attaching the bracket. Attach each support bracket to the under side of the
table, also shown in Figure 10 on page 16. Place spacers above each slot receiving a screw to
mount the table on the support. Lay the table extension on top of the spacers and insert the screws.
Slide the table extension tight to the table and shim as necessary.
Bracket
Screws
Hinge
Screws