Challenge Titan 265, Инструкция по эксплуатации

Страница: 33 / 88

6.0 Operation
32
6.13.7 Exiting a Job
To exit an open job, press the soft-key “B” (Job) to return to the job mode screen, or press the soft-
key “D” (Exit) to exit to the send mode screen.
6.14 An Example Job
The following is an example of how to program a job, which will be used to make two cuts: one at 8.5”
and one at 11”.
1. Turn on the machine and press CLEAR to preset the backgauge. Press the soft-key “B”
(Job) to go to job mode.
2. Type in a new job number and press ENTER. Note: It must be a number that does not
correspond to an existing job. All existing jobs will be displayed on the screen (you may have
to scroll through them to see them all). If you wish to replace an existing job with the new job,
first erase the existing job by moving the cursor to it and press the soft-key “C” (Erase). Now
type in the new number and press ENTER. In this example, job #’s 1, 2, 5, and 6 already
exist. We will use job # 7 for our new job. Press “7” and ENTER.
3. The cursor will move down to the new job number. At this point, press the right arrow key
once to move the cursor to the first character position. Now name the job “8.5 X 11”. To do
this, press “8” on the number keypad. Then press the decimal “.” key and so on. To enter
the spaces and the letter “X”, use the up and down arrow keys to toggle through the alphabet
and press the right arrow key to move to the next character position. When the last character
has been typed in, the display should look similar to the one shown below:
>
1> JOB 1
2> TESTJOB
5> BOBS JOB *
6>
7>
8.5 X 11_
+
A) Lock
C) Erase
B) Copy D) Exit