Cerus Industrial Titan CI-001-GS2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 178

5-3
5.3 Moving to other groups
z
There are 4 different parameter groups in GS series as shown below.
Drive group Basic parameters necessary for the inverter to run. Parameters
such as Target frequency, Accel/Decel time settable.
Function group 1 Basic function parameters to adjust output frequency and
voltage.
Function group 2 Advanced function parameters to set parameters for such as
PID Operation and second motor operation.
I/O (Input/Output)
group Parameters necessary to make up a sequence using Multi-
function input/output terminal.
z
Moving to other parameter groups
is only available in the first code of each group as the
figure shown below.
Moving to other groups using the Right (
X
)
key
Moving to other groups using the Left (
W
) key
Function
group 1
Function
group 2
I/O group
Drive group
Q
Function
group 1
Function
group 2
I/O group
Drive group
Q
* Target frequency can be set at
0.0
(the 1
st
code of drive group). Even though the preset value is 0.0, it is
user-settable. The changed frequency will be displayed after it is changed.
I/O group
FU group 2
FU group 1
Drive group