Cerus Industrial Titan CI-001-GS2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 95 / 178

10-2
z
Starting DC brake
Group Display Parameter Name Setting Range Default Unit
Function
group 1
F12 [DC Brake start voltage] - 0 ~ 200 50 %
F13 [DC Brake start time] - 0 ~ 60 0 sec
ƒ
F12: It sets the level as a percent of H33 – [Motor rated current].
ƒ
F13: Motor accelerates after DC voltage is applied for the set time.
ჹ
Caution:
If excessive DC Brake voltage is set or DC Brake time is set too long, it may cause motor
overheating and damage to the motor.
Setting F12 or F13 to 0 will disable Starting DC brake.
t: After F13 - [DC Brake start time], the frequency is increasing after DC voltage is
applied until the time t.
z
DC brake at a stop
Group Display Parameter Name Setting Range Default Unit
Function
group 1
F12 [DC Brake start voltage] -
0 ~ 200 50 %
I/O group
I19
[Multi-function Input
terminal P3 Function select]
11
0 ~ 24 2
ƒ
F12: It sets the level as a percent of H33 – [Motor rated current].
ƒ
Select a terminal to issue a command of DC brake at a stop among P1 to P8.
ƒ
If P3 terminal is set for this function, set I19 to 11 {DC brake during stop}.
ჹ
Caution:
If excessive DC Brake voltage is set or DC Brake time is set too long, it may cause motor
overheating and damage to the motor.
Freq.
Voltage
Run
command
F13 t
F12
Voltage
Run
command
F12
P3