Cerus Industrial Titan CI-001-GS2, Инструкция по установке, эксплуатации и обслуживанию

Страница: 48 / 178

7-3
z
Function group 1
LED
display
Parameter
name
Min/Max
range
Description
Factory
defaults
Adj.
during
run
Page
F 0 [Jump code] 0 ~ 60 Sets the parameter code number
to jump. 1 O 5-5
0 Fwd and rev run enable
1 Forward run disable
F 1
[Forward/
Reverse run
disable]
0 ~ 2
2 Reverse run disable
0 X 9-10
F 2 [Accel
pattern]
0
Linear
F 3 [Decel
pattern]
0 ~ 1
1
S-curve
0 X 9-15
0
Decelerate to stop
1 DC brake to stop
F 4 [Stop mode
select] 0 ~ 2
2 Free run to stop
0 X 9-20
F 8
1)
[DC Brake
start
frequency] 0.1 ~ 60
[Hz]
This parameter sets DC brake
start frequency.
It cannot be set below F23 - [Start
frequency]. 5.00 X 10-1
F 9
[DC Brake
wait time] 0 ~ 60
[sec] When DC brake frequency is
reached, the inverter holds the
output for the setting time before
starting DC brake. 0.1 X 10-1
F10
[DC Brake
voltage] 0 ~ 200
[%] This parameter sets the amount
of DC voltage applied to a motor.
It is set in percent of H33 –
[Motor rated current]. 50 X 10-1
F11
[DC Brake
time] 0 ~ 60
[sec] This parameter sets the time
taken to apply DC current to a
motor while motor is at a stop. 1.0 X 10-1
F12 [DC Brake
start voltage] 0 ~ 200
[%] This parameter sets the amount
of DC voltage before a motor
starts to run.
It is set in percent of H33 –
[Motor rated current]. 50 X 10-2
F13 [DC Brake
start time] 0 ~ 60
[sec] DC voltage is applied to the
motor for DC Brake start time
before motor accelerates. 0 X 10-2
F14 [Time for
magnetizing
a motor] 0 ~ 60
[sec] This parameter applies the
current to a motor for the set time
before motor accelerates during
Sensorless vector control. 1.0 X 10-11
F20 [Jog
frequency] 0 ~ 400
[Hz] This parameter sets the
frequency for Jog operation.
It cannot be set above F21 –
[Max frequency]. 10.00 O 10-3
1)
: Only displayed when F 4 is set to 1 (DC brake to stop).