Carver 56 Voyager SE, Руководство пользователя

Страница: 184 / 209

W
INTERIZATION AND
S
TORAGE
S
ECTION
8
5627 11/03
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s sanitation system. Using the wrong type of antifreeze can damage
the sanitation system. The repair of such damage is not included under
the terms of the Carver Limited Warranty.
2. Flush 10 gallons of nontoxic recreational vehicle antifreeze through
each toilet.
3. Under the boat, place a large bucket beneath the overboard dis-
charge fitting to collect antifreeze pumped out later in this proce-
dure. Refer to 9.7.3 Thru-Hull Fittings for the exact location of the
overboard discharge fitting.
4. Open the overboard discharge seacock.
5. Turn the waste tank selector Y-valve to the port waste tank position.
6. Turn the “house” battery bank master disconnect switch to the “ON”
position.
7. On the Safety Breaker Panel, switch the Main - One circuit breaker
“ON.”
8. On the DC Control Center, switch the Systems DC Main circuit
breaker “ON,” then switch the Waste Pump circuit breaker “ON.”
9. Turn the overboard discharge pump switch “ON.”
10. When a steady stream of antifreeze flows from the overboard dis-
charge fitting, turn the overboard discharge pump switch “OFF.”
11. Turn the waste tank selector Y-valve to the starboard waste tank
position.
12. Repeat steps 9 and 10 for the starboard waste tank.
13. Close the overboard discharge seacock.
14. On the DC Control Center, switch the Waste Pump circuit breaker
“OFF.”
15. When you remove your boat from storage and prepare to use it again:
a. Flush 5 gallons of fresh water through each toilet.
Open Closed