Carver 56 Voyager SE, Руководство пользователя

Страница: 83 / 209

S
ECTION
3 AC E
LECTRICAL
S
YSTEM
5627 5/04
3.3.2.4 Load Current (Ammeter)
The ammeter indicates the amount of current that is being drawn by the
AC electrical equipment, as selected by the Select Load switch, described
below.
When either the Shore or Generator circuit breaker group is “ON,” all
other breakers on the AC Control Center are “OFF,” and the voltmeter is
reading between 210 and 240 volts, the ammeter should read zero amps.
As you switch the circuit breakers on the AC Control Center “ON” and
turn on their associated equipment or turn on equipment plugged into
the AC receptacles, the ammeter readings increase above zero amps.
Refer to 3.4 Electrical Loads for information on the AC electrical
system load limits.
3.3.2.5 Select Load Switch
This switch determines which AC electrical equipments’ load is shown on
the ammeter. The “Line 1” and “Line 2” equipment are noted on the AC
Control Center.
3.3.2.6 AC Power Selector
The AC Power Selector circuit breaker groups allow you to provide
power to the other circuit breakers on the AC Control Center. Each
breaker group consists of either two (for Europe/Australia) or three (for
North and South America/Asia) circuit breakers that operate together.
A sliding lockout plate prevents you from switching “ON” both the Shore
and Generator breaker groups for the same Line circuit. Slide the lock-
out plate to the position necessary to expose the breaker group that you
wish to use.
For the North and South American/Asia AC Control Center:
Shore - Switch this breaker group “ON” if you are using a shore power
source to provide electricity to the AC electrical system.
Generator - Switch this breaker group “ON” if you are using the genera-
tor to provide electricity to the AC electrical system.
For the European/Australian AC Control Center:
Shore 1 - Switch this breaker group “ON” if you are using a shore power
source to provide electricity to the Line 1 circuit breakers.
Generator (upper) - Switch this breaker group “ON” if you are using
the generator to provide electricity to the Line 1 circuit breakers.