Carver 56 Voyager SE, Руководство пользователя

Страница: 182 / 209

W
INTERIZATION AND
S
TORAGE
S
ECTION
8
5627 11/03
Refer to 4.3 Raw Water Washdowns for a description of your boat’s raw
water washdown system.
1. Close the seacock that supplies the raw water washdown pump with
seawater.
2. Disconnect the end of the hose that is attached to the washdown side
of the seacock.
You must use a nontoxic, non-alcohol, RV-type (pink) antifreeze in your
boat’s raw water washdown system. Using the wrong type of antifreeze
can damage the raw water washdown system. The repair of such damage
is not included under the terms of the Carver Limited Warranty.
3. Place the disconnected hose end into a bucket that contains about a
gallon of nontoxic recreational vehicle antifreeze.
4. Remove the hose(s) from the bow and transom raw water washdown
fittings.
5. Place a bucket under the washdown fittings to catch the antifreeze,
which can be reused.
6. Turn the “house” battery bank master disconnect switch to the “ON”
position.
7. On the Safety Breaker Panel, switch the Main - One circuit breaker
“ON.”
8. On the DC Control Center, switch the Systems DC Main circuit
breaker “ON,” then switch the Washdown Pump circuit breaker
“ON.”
9. When a steady stream of antifreeze flows from the washdown fit-
tings, switch the Washdown Pump circuit breaker “OFF.”
10. Reconnect the hose(s) to the washdown fitting(s).
11. Reconnect the hose that was disconnected in Step 2.
8.3.7 Bilge
Refer to 4.4 Bilge System for a description of your boat’s bilge system.
1. Open the hull drain. Leave the drain open while your boat is in
storage.
Open Closed