Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 9 / 35

S T E P 3
S T E P 3 – E n d p l a t e s
14 docs.carbide3d.com support@carbide3d.com 15
3.1 Install Front‑Right
Endplate
1. Position the front-right endplate near the front
end of the Y-Right rail.
a. Power button faces front.
b. BitSetter extends to left.
2. Connect the 4-pin power and the 3-pin
BitSetter leads to the corresponding extension
cables exiting the front of the rail. See Figs.
3-3 and 3-4 .
Figure 3-2 Figure 3-4
NOTE: Connectors are polarized and will only
connect one way. Do not force a connection. See
Fig. 3-3 .
3. Tuck the connected cables into the rail cavity,
so the endplate sits flush against the end of
the rail.
4. Use a 4mm hex key and four (4) M6×12mm low
profile SHCS to secure the endplate to the rail.
Fully tighten.
Figure 3-3
NOTE: Be careful not to pinch the wires between
the rail and endplate.
NOTE: Be careful not to cross-thread the screws.