S T E P 6
S T E P 6 – D r a g C h a i n
32
docs.carbide3d.com
33
6.1 Install Head Bracket
1. Position the drag chain head bracket on the
back of X/Z assembly
(see
Fig. 6-2)
:
a. Upper-left corner (upper-right corner when
viewed from back).
b. Flange down, threaded holes to back.
2. Use a 3mm hex key and two (2) M5×6mm
BHCS to secure the bracket to the
X/Z assembly. Fully tighten.
Figure 6-3
6.2 Install X‑Axis Drag Chain
1.
Position X-Axis drag chain along the top of the
X-Axis gantry.
a.
Head of the chain to the left; the tail to the
right, ending at the right gantry endplate.
b.
Head has all female connectors.
c.
Head curls up and attaches to the head
bracket.
2.
Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the drag chain to the head
bracket. Fully tighten.
See
Fig. 6-3
.
Figure 6-4
6.3 Attach Transition Bracket
1. Position the Z-shaped X/Y transition bracket
on the head of the Y-Axis drag chain.
See
Fig. 6-4
.
a. Head of chain has all female connectors.
b. Longer arm of the bracket attaches to the
flat side of the head of the drag chain.
2. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the bracket. Fully tighten.
Figure 6-2
Содержание Shapeoko PRO
Страница 1: ...Shapeoko PRO ASSEMBLY GUIDE...