Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 10 / 35

S T E P 3
S T E P 3 – E n d p l a t e s
16 docs.carbide3d.com support@carbide3d.com 17
3.2 Install Back‑Right
Endplate
1. Position the back-right endplate at the back
end of the Y-Right rail. See Fig. 3-5 .
a. Proximity switch to outside/front.
2. Use a 4mm hex key and four (4) M6×12mm low
profile SHCS to secure the endplate to the rail.
Fully tighten.
Figure 3-5
3.3 Install Left Endplates
1. Position the two remaining endplates at either
end of the Y-Left rail. See Fig. 3-6 .
a. Countersunk holes to the outside; flat side
flush against the rail ends.
b. Tapered corners to the outside/top.
2. Use a 4mm hex key and four (4) M6×12mm low
profile SHCS to secure each endplate to the
rail. Fully tighten.
Figure 3-6