Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 12 / 35

S T E P 4
S T E P 4 – G a n t r y
20 docs.carbide3d.com support@carbide3d.com 21
4.1 Install X‑Axis Gantry
1. Position the X-Axis gantry across the center
of the baseframe, resting it on the Y-Left and
Y-Right carrier plates/bearing blocks. See
Figs. 4-2 and 4-4 .
a. Gantry linear rails and carrier plate to front.
b. Left and right gantry endplates rest on top
of the bearing blocks to the inside of the
Y-Axis carrier plates.
Figure 4-2
4.2 Install X‑Axis Drag Chain
Support Panel
1. Position the support panel across the top-back
of the gantry. See Fig. 4-3 .
a. Countersunk holes up.
b. Tapered corners to back.
c. Two threaded M3 holes to left.
2. Use a 2.5mm hex key and five (5) M4×8mm
FHS to secure the panel to the gantry.
a. Start all screws before fully tightening.
Figure 4-4
NOTE: Tolerances are tight. Be sure the gantry
is centered. If necessary, tilt the still loose Y-rails
outward to fit the gantry between the plates.
2. Align the holes in the two Y-Axis carrier plates
with the left and right gantry endplates.
3. Use a 4mm hex key and six (6) M6×12mm
BHCS to loosely attach the gantry to the
carrier plates. See Fig. 4-4 .
a. Snug the screws, then back out ¼ turn.
Figure 4-3