Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 16 / 35

S T E P 5
S T E P 5 – X / Z A s s e m b l y
28 docs.carbide3d.com support@carbide3d.com 29
5.1 Install X/Z Assembly
1. Use a 4mm hex key to remove the M5×25mm
SHCS shipping screw from the front of the
X-Axis carrier plate, allowing it to slide freely
left and right.
2. Position the X/Z assembly over the front of the
X-Axis carrier plate. See Fig. 5-2 .
a. Z-Axis plate facing front.
b. Z-Axis stepper motor on top.
3. Use a 4mm hex key and four (4) M6×12mm
BHCS to secure the X/Z assembly to the
X-Axis carrier plate. Fully tighten.
Figure 5-2
5.2 Install X‑Motor and Belt
1. Attach one end of the belt to one end of the
X-Axis gantry, threading about 3 inches of belt
through the belt clip. (Refer back to Steps 4.3
and 4.4 .) See Fig. 5-4 .
2. Thread the belt, teeth down under the two
idlers on the back of the X/Z assembly.
3. Use a small hex key to pull a large loop of belt
up between the two idlers and into the motor
housing. See Fig. 5-4 .
Figure 5-4
4. Position the X-motor over the threaded screw
holes on the motor housing. See Fig. 5-3 .
a. Motor pulley faces into motor housing,
under the belt loop.
b. Motor lead cables extend up.
5. Use a 4mm hex key and four (4) M5×12mm
SHCS to secure the X-motor to the motor
housing. Fully tighten.
6. Pull the slack out of the belt and secure the
free end to the other end of the X-Axis gantry.
(Refer back to Steps 4.3 and 4.4 .)
Figure 5-3