Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 24 / 35

S T E P 7
S T E P 7 – R o u t e r
44 docs.carbide3d.com support@carbide3d.com 45
7.7 Install X‑Axis Drag Chain
1. Position the X-Axis drag chain along the top of
the X-Axis gantry.
a. Head of the drag chain attaches to the
head bracket. See Fig. 7-10 .
b. Body of the chain extends right from the
head bracket before curling down and left,
ending at the left gantry endplate.
2. Use a 2mm hex key and two (2) M3×6mm
BHCS to secure the drag chain. Fully tighten.
Figure 7-10
7.9 Secure Tails of the X‑ and
Y‑Axis Drag Chains
1. Position the tail of the X-Axis drag chain over
the two M3 screw holes at the left end of the
X-Axis drag chain support panel. See Fig. 7-11 .
2. Use a 2mm hex key and the two (2) M3×6mm
BHCS to secure the tail to the support panel.
3. Position the tail of the Y-Axis drag chain over
the two M3 screw holes on the Y-Left drag
chain support panel. See Fig. 7-11 .
Figure 7-11
4. Use a 2mm hex key and the two (2) remaining
M3×6mm BHCS to secure the tail to the
support panel.
5. Remove the slack from the router power
cable.
7.8 Install Y‑Axis Drag Chain
1. Use a 4mm hex key to remove the back
two (2) M6×12mm BHCS from the left gantry
endplate.
2. Position the transition bracket and Y-Axis drag
chain combo alongside the Y-Left rail. See
Fig. 7-11 .
a. Align the bracket with the two M6 screw
holes.
b. Short arm of the bracket rests on top of
the gantry.
3. Use a 4mm hex key and the two (2) M6×12mm
BHCS to secure the bracket. Fully tighten.
a. The body of the drag chain extends forward
from the bracket before curling down and back.