Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 26 / 35

S T E P 8
S T E P 8 – H y b r i d T a b l e
48 docs.carbide3d.com support@carbide3d.com 49
8.1 Install HDPE Filler Strips
(Optional)
1. Position the nine (9) HDPE filler strips, from
front to back, in the narrow machined-
channels in the baseframe crossmembers.
See Fig. 8-2 .
2. Use a 2.5mm hex key and four (4) M4×6mm
BHCS to secure each filler strip to the
baseframe. Fully tighten.
Figure 8-3
8.3 Install MDF Strips
1. Position the ten (10) MDF strips inside the
hybrid extrusions. See Fig. 8-4 .
2. Use a 5mm hex key and four M6×20mm SHCS
to secure each MDF strip. Fully tighten.
a. Insert screws in order: front, back, center.
Figure 8-4
8.2 Install Hybrid Extrusions
1. Position the ten (10) hybrid extrusions, from
front to back, between the filler strips. See
Fig. 8-3 .
2. Use a 4mm hex key and eight (8) M6×10mm
FHS to secure each hybrid extrusion to the
baseframe.
a. Loosely insert all screws in an extrusion
before fully tightening.
NOTE: We do not recommend using power tools
here; the risk of cross-threading is too high.
Figure 8-2