Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 22 / 35

S T E P 7
S T E P 7 – R o u t e r
40 docs.carbide3d.com support@carbide3d.com 41
7.3 Prepare Drag Chains
1. Open both drag chains.
a. Lay chains flat, hinged-side up, and use a
hex key to pry open the links from one side.
See Fig. 7-5 .
2. Lay out the longer X-Axis drag chain as shown
in Figs. 7-6 and 7-6 inset .
a. Bottom (flat side) of both the head and tail
links face the front of the machine.
Figure 7-6
7.4 Insert Power Cable
1. Insert the router power cable through both
drag chains and close up the links. See
Fig. 7-7 .
2. Snap the tail links back onto both drag chains.
See Fig. 7-7 .
NOTE: The power cable enters the head of the
Y-Axis drag chain BEHIND the head link.
Figure 7-7
Figure 7-5
3. Lay out the shorter Y-Axis drag chain as shown
in Figs. 7-6 and 7-6 inset .
a. Head and tail links are interchangeable.
4. Use a small screwdriver to pry the tail links off
both drag chains.
5. Remove the first link hinge at the head of the
Y-Axis drag chain.