Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 5 / 35

S T E P 1
S T E P 1 – B a s e f r a m e
6 docs.carbide3d.com support@carbide3d.com 7
1.1 Position Crossmembers
and Drag Chain Support Panels
1. Position the four crossmembers horizontally
across your table. See Fig. 1-2 .
a. Standoffs up, about 10 inches apart.
2. Check each standoff and make sure each is
finger-tight.
Figure 1-2
1.2 Assemble the Baseframe
1. Use a 4mm hex key and eight (8) M6×6mm
BHCS to loosely attach the support panels to
the crossmembers. See Figs. 1-2 and 1-3 .
a. Snug the screws, then back out ¼ turn.
b. Don’t worry about squaring the baseframe
yet.
Figure 1-3
1.3 Install Cable Tie Mounts
1. Use a 2mm hex key and four (4) M3×6mm
BHCS to secure two (2) cable tie mounts to
each support panel. See Fig. 1-3 .
a. Secure mounts to the wide-set M3 holes
toward the back.
NOTE: Set aside the pack of zip ties for cable
cleanup later.
3. Position the two support panels, front to
back, across the outside edges of the four
crossmembers. See Figs. 1-2 and 1-3 .
a. M3 threaded holes to the outside.
b. Two close-set M3 holes toward the front.
c. Two wide-set M3 holes toward the back.