Carbide 3D Shapeoko PRO, Инструкция по сборке

Страница: 14 / 35

S T E P 4
S T E P 4 – G a n t r y
24 docs.carbide3d.com support@carbide3d.com 25
5. Thread a second belt clip onto the free end of
the belt.
6. Firmly hold the clip flat against the rail.
7. Adjust the length of the belt so that there is a
2–3mm gap between the clip and the front-left
endplate. See Fig. 4-8 .
8. Use a 4mm hex key and one (1) M5×12mm
SHCS to secure the clip to the endplate.
a. Maintain downward pressure on the clip.
b. Fully tighten the screw until the belt snaps
back against the rail when gently lifted.
Figure 4-8
4.5 Square the Machine
1. Use a 5mm hex key to remove the M6×35mm
SHCS shipping screws from both Y-Axis carrier
plates, allowing the gantry to slide freely front
and back.
2. Slide the gantry as far forward as it will go.
3. Adjust the squareness of the baseframe
until both ends of the gantry touch the front
endplates. There should be NO GAPS on
either side. See Fig. 4-9 .
4. Use a 5mm hex key and fully tighten the front-
left and front-right shoulder bolts securing the
Y-rails to the baseframe.
Figure 4-9
a. Fully tighten the remaining shoulder bolts,
moving front to back, sliding the gantry as
you go, and alternating sides.
5. Slide the gantry as far back as it will go.
Ensure there are no gaps between the gantry
and the back endplates.
6. Use a 4mm hex key to fully tighten the six (6)
M6×12mm BHCS securing the gantry to the
left and right Y-Axis carrier plates.
7. Use a 4mm hex key to fully tighten the eight
(8) M6×6mm BHCS securing the left and right
drag chain support panels to the baseframe.
NOTE: Do not overstretch the belt. Stretching
more than 3mm could damage the belt or motors.
9. Repeat Steps 4.3 and 4.4 to install the second
belt to the Y-Right rail.