Canon CXDI-1, Руководство по эксплуатации

Страница: 123 / 170

Continued on the following page >>
10. Before Calling a Service Engineer
– 115 –
-132
Capture Board Error
Touch [OK] to close the window, and then see
1.2 Shutting Down the CXDI ( → page 5) ,
and turn off the CXDI.
When these errors occur, note the error code
and contact a Canon representative or
distributor.
Capture Board Error. Call a service engineer.
-134
Capture Board: Sequence Error
Failed to synchronize with the sensor unit. Call a service engineer.
-135
Capture Board: Sequence Error
X-ray monitor in sensor unit failed to detect the beginning of irradiation.
-136
Capture Board: Data Transmit Error
Failed to transmit the data. Call a service engineer.
-137
Capture Board: Control Line Error
Control line error has occurred in capture board. Call a service engineer.
-138
Sensor Unit: Sensor Analogue Power Supply Error
Sensor Analogue Power Supply was detected. Call a service engineer.
-139
Grid ID Readout Error
Touch
[OK]
to close the window. Exposure can
be continued.
When these errors occur, note the error code
and contact a Canon representative or
distributor.
Grid ID readout error has been detected.
-140
Acquisition Parameter Error Touch [OK] to close the window, and then see
1.2 Shutting Down the CXDI (
→
page 5) ,
and turn off the CXDI.
When these errors occur, note the error code
and contact a Canon representative or
distributor.
Detected Illegal Parameter Error.
-141
LUT Write Error
Touch [OK] to close the window, and then see
8. Calibration ( → page 97) to perform
calibration.
Quit the exam and perform calibration.
-143
Calibration Table Error
Perform Calibration.
-144
Sensor Unit Configuration Error
Touch [OK] to close the window, and then see
1.2 Shutting Down the CXDI (
→
page 5) ,
and turn off the CXDI.
When these errors occur, note the error code
and contact a Canon representative or
distributor.
Incorrect Sensor Unit Configuration. Call a service engineer.
-145
Sensor Unit: Firmware Write Error
The firmware is incorrect.
-146
Capture Device Access Error
Detected Communication Error
Either an error occurred in the sensor, or the sensor power may be turned off.
-147
Capture Device Access Error If sensor power is turned off, turn the sensor
power on and try performing the operation
again.
If sensor power is on, note the error code and
contact a Canon representative or distributor.
Detected Communication Error
Either an error occurred in the sensor, or the sensor power may be turned off.
-148
Sensor Unregistered Error.
Touch [OK] to close the window, and then
connect a registered sensor.
The connected sensor cannot be used because it is unregistered.
Error
Code
Error Message (Upper box: Error type
Lower box: Error description)
Remedy