Bush Hog BSR Series, Руководство оператора, Страница: 92 / 96

MAINTENANCE
RHP Series Rakes 03/14 Maintenance Section 5-8
© 2014 Alamo Group Inc.
MAINTENANCE
Replacing Wheel Tines
To replace a tine:
1. Remove two round-head bolts (A), nuts, clip
and tine.
2. Install new tine. Fasten with clip, round-head
bolts (A) and nuts.
Identifying Left-Hand and Right-Hand Rake Wheels
To identify left-hand and right-hand rake wheels:
1. Put rake wheels against a wall with tine
mounting clamp plates facing inward.
2. If the last bend in the tines curve to a clockwise
direction, it is left-hand rake wheel.(A).
3. If the tines curve in a counterclockwise
direction, it is a right-hand rake wheel (B).
STORAGE
End of Season
To prepare your Rake for storage:
1. Clean the rake following instructions and allow it to dry. Trash and dirt will draw moisture and cause rust.
2. Thoroughly tighten all screws, bolts, nuts and hydraulic fittings.
3. Store the rake on a clean, dry surface in the down (working) position.
4. Grease the machine thoroughly and then cover it completely.
5. Apply a thin layer of grease on exposed cylinder rods to prevent rusting.
6. Check hydraulic hoses for deterioration and replace if necessary.
7. Lubricate all points and slides before storage. This prevents corrosion.
8. Repair or replace worn or broken parts
9. Paint all parts where necessary.
10. Replace damaged or missing decals.
11. List replacement parts needed and order then early.
NOTE: Now would be a good time to replace all damaged or worn parts, and have a machine in perfect
condition ready for use the next season.