Buell 2002 P3, Руководство по обслуживанию, Страница: 215 / 400

3-68 2002 Buell P3: Engine
HOME
14. See Figure 3-121. Installed inner races are identified at
the factory as shown.
15. See Figure 3-122. Outer races are identified at the fac-
tory as shown.
NOTE
The different sizes of crankcase sets and flywheel assem-
blies will not have separate part numbers. That is, a replace-
ment crankcase set may have a class 1, 2 or 3 pinion outer
race. Replacement flywheel assemblies will have either a
class A or B inner race.
16. See Figure 3-123. Pinion bearings are identified as
shown.
BEARING SELECTION
See Table 3-15. Pinion Shaft Bearing Selection. Select bear-
ings using the identification information given for inner and
outer races and bearings.
NOTE
If either inner or outer race show wear, measure both races to
confirm correct bearing fit.
Figure 3-121. Factory Inner Race Sizes
* Paint dot on end of spline
SERVICE WEAR LIMIT: 1.2492 in. (31.7297 mm)
RACE OD CLASS IDENTIFICATION*
1.2498-1.2500 in.
(31.7449-31.7500 mm)
A White
1.2496-1.2498 in.
(31.7398-31.7449 mm)
B Green
a0131x3x
Inner
Race
Paint Dot
Figure 3-122. Factory Outer Race Sizes
Figure 3-123. Bearing Identification
* Stamped number inside crankcase near race
SERVICE WEAR LIMIT: 1.5672 in. (39.8069 mm)
RACE ID
CLASS
NO.
STAMPED
IDENTIFICATION*
1.5646-1.5648 in.
(39.7408-39.7459 mm)
1 1
1.5648-1.5650 in.
(39.7459-39.7510 mm)
2 2
1.5650-1.5652 in.
(39.7510-39.7561 mm)
3 3
ID
a0134x3x
Outer Race
Right Crank-
case Half
Stamped
Class No.
A – Roller OD cannot be
measured to required
accuracy with
micrometer
* Package color
ROLLER OD (A) IDENTIFICATION*
Largest
Smallest
Red
Blue
White (Grey)
Green
a0133x3x