install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V5
To Access PowerAux:
1.
Set up an output to PowerAux 1 or PowerAux 2 in Granite Output Assignments, as
described in section 1.8.
2.
Assign an input to Aux 1 or Aux 2, as described in section 4.11.1.
3.
Select the
[Aux 1]
or
[Aux 2]
button in the Destination Row and the PixPad will
display the following:
3.
In the Aux Modifier PixPad select the
[Pwr Aux]
PixButton.
The PowerAux PixPad will appear, as shown above.
4.
Select the desired Key(s) to be overlaid onto the Aux output either
[Key 1 OnOff]
,
[Key 2 OnOff]
,
[Key 3 OnOff], [Key 4 OnOff], [Key 5 OnOff]
and/or
[Key 6
OnOff].
The display will read out the keys you have on Aux 1. The Keyers will fade
on/off based off the Keyer Rate, as described in section 4.4.7.
4.11.4
NOTE:
Although you can use PowerAux on the Preview and Program outputs, if a keyer is already on
Preview or Program, you can not remove the keyer from only the PowerAux. You can, however, keep the
keyer on PowerAux, if you remove it from Preview or Program.
Aux 1 Modifier PixPad Aux 1 PowerAux PixPad