bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 56 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d0
561
9.
fm
MAINTENANCE MANUAL
BRP-Powertrain
24-20-00
Page 6
July 01/2012
REMOVAL
Preparation
- Drain coolant. See relevant Maintenance
Manual Line for the 912 i Series engine type.
- Remove adjacent assemblies (electric starter,
water pump).
- Remove coolant hoses from cylinder head.
- Remove rev counter assy. To do this, see
section 76-70-00 Sensors and actuators.
NOTE:
The assemblies and lines are only to be
removed if necessary and only as far as
is necessary!
IGNITION HOUSING - REMOVAL
Fig. 1
Fig. 2
NOTE:
Push airbox upwards and wedge in
place.
Fig. 3
m
WARNUNG
NOTICE
Use appropriate protective coverings to prevent
the ingress of foreign bodies into all dis-
connected lines and connections.
Step Procedure
1 Detach the electrical connection to the
stator by disconnecting the controller con-
nector. Mark before detaching!
2 Press on the catch and disconnect the
connector.
1. Controller connector 2. Connection socket
Step Procedure
3 Loosen the airbox bracket. Loosen the
hex. nut and remove it along with the
washer.
1. Washer A 6.4 2. M6 hex. nut
3. Rubber buffer 20x10xM6
Step Procedure
4 Loosen 2 Allen screws M5x45 and
hex. nuts M5 on electric starter.
1. M5x45 Allen screw 2. M5 hex. nut
3. OPS pressure sensor (oil)
Step Procedure
5 Loosen 5 M6x30 and 2 M6x50 Allen
screws with washers 6.4.
6 Disconnect OPS pressure sensor.