bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 123 / 458

Effectivity: 912 i Series
Edition 1/Rev. 0
d
059
33.
fm
MAINTENANCE MANUAL
BRP-Powertrain
71-00-00
Page 15
July 01/2012
MAINTENANCE
As well as the maintenance and special checks,
see the relevant Maintenance Manual Line for
the respective 912 i Series engine type.
REMOVAL
POWER PLANT - REMOVAL
Preparation
To remove the engine, carry out the following
steps. If these steps are included and listed in
the instructions of the aircraft manufacturer (see
"Documentation of the aircraft manufacturer"),
then the steps given here should be treated as
additional information.
- Secure the aircraft appropriately
- Switch the ignition key OFF
- Disconnect the battery
- Switch the tank selector switch OFF
- Remove cowling
- Disconnect fuel lines
- Drain the residual fuel out of the lines and
seal the lines
- Drain the coolant
- Drain the oil
DISCONNECTING THE LINES TO THE
AIRCRAFT
Disconnect all the extension lines between the
engine and the aircraft.
Starter relay:
See Fig. 4.
Fig. 4
Ambient pressure sensor:
See Fig. 5
.
Fig. 5
Step Procedure
1 Remove the spinner and propeller (see
section 61-00-00).
Step Procedure
1 Loosen M6 hex. nut and remove it along
with the 6.4 washer. Pull off faston
connector. Press the lock to pull off the fa-
ston connector.
2 Loosen the earthing Allen screw.
1. Starter relay 2. M6 hex. nut
3. 6.4 washer 4. Faston connector
5. Earthing 6. Allen screw
Step Procedure
1 Push in the tab on the top of the connector
and at the same time pull the connector
out of the connection socket.
1. Tab 2. Connection socket