bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 341 / 458

Effectivity: 912 i Series
Edition 1/Rev. 1
d
066
74.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-10-00
Page 25
October 01/2013
The ECU software flashing process with B.U.D.S.
Aircraft
Fig. 31
Fig. 32
NOTE:
If the ECU at this time is supplied with
power, a restart is required.
NOTE:
If connection status lamps would not
turn to GREEN, try to disconnect and
reconnect the power adapter or try
turning the “LANE A“ and “LANE B“
Switches to “OFF“ and then to “ON“
again.
Fig. 33
Step Procedure
1 Open B.U.D.S. Aircraft Software.
2 Open the “Preference“-Window and make
sure that a Baud Rate of 500 kbs is se-
lected.
3 Close the window “Preferences“ with
“OK“.
B.U.D.S. Aircraft „Preferences“
Step Procedure
4 Change to “Maintenance Mode“-Tab.
B.U.D.S. Aircraft „Maintenance Mode“
09962
09961
Step Procedure
5 Wait until the Connection State Indicators
(Bottom-Right) turn to RED.
6 “Master“ Switch to “ON“.
7 “Backup Battery“ Switch to “ON“.
8 Turn “LANE A“ Switch and “LANE B“
Switch to “ON“. The Connection State In-
dicators will turn to YELLOW if all connec-
tions are done properly.
9 Please wait until the Connection State In-
dicator turn to GREEN and the fields in
“Connection“-Tab (ECU Configuration
Data and User Configurable Parameters)
fill with data.
B.U.D.S. Aircraft „Maintenance Mode“
Step Procedure
10 Check the currently installed ECU Soft-
wareversion and the set Engine Type.
09963