bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 343 / 458

Effectivity: 912 i Series
Edition 1/Rev. 1
d
066
74.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-10-00
Page 27
October 01/2013
Check of the Software version
FINISHING WORK
- Attach all the necessary fastenings (e.g.
cable ties, holders, clamps etc.) of the wiring
harness.
- Transfer the actual data documented when
removing the old ECU to the newly installed
ECU.
- Delete the error memory of the new ECU.
- Carry out an engine test run. See section 70-
00-00.
- Read out the ECU.
Step Procedure
1 After the Software flashing process has
finished, the “Connection“-Tab will be
shown. Check if the Software P/N equals
the Softwareversion which was intended
to be installed.
2 Change to section “Diagnostic“ Mode.
3 A window will open to inform the user that
a reboot of the ECU is required when
changig from “Maintenance“ to “Diagnos-
tic“-Mode. Confirm the information with
“OK“.
4 Reboot the ECU by turning the “Master
Switch“ or the “LANE A“, “LANE B“
Switches to “OFF“ and “ON“ again.
5 Check warning lamp indicators. If both
warning lamp indicators (section “LANE
Health“/top toolbar) start to flash “RED“
after rebooting the ECU, check compati-
bility between set Engine type and ECU
Softwareversion.
6 Change to “Health“-Tab and check the
Sensor Status and Device Status. If there
are Errors/Events the ECU might be dam-
aged and further investigation needs to be
done.
7 The Software flashing process itself is
now complete. Turn the “Master“ Switch“,
the “Battery Backup“-Switch and the
“LANE A/B“ Switches back to “OFF“.
8 Remove all wiring connections.