bpr Rotax 912 i Series, Руководство по обслуживанию, Страница: 342 / 458

Effectivity: 912 i Series
Edition 1/Rev. 1
d0
667
4.
fm
MAINTENANCE MANUAL
BRP-Powertrain
76-10-00
Page 26
October 01/2013
NOTE:
The currently installed ECU Software
version (“Software P/N“/section “
ECU Configuration Data“) and the set
Engine Type (section “User Configu-
rable Parameters“) can be seen in the
“Connection“ Tab. The last three dig-
its of the “Software P/N“ illustrate the
currently installed ECU Software ver-
sion.
Fig. 34
NOTE:
If the Software flashing process was
interrupted (e.g. the ECU was discon-
nected from the computer) it is neces-
sary to restart the flashing process
with the desired Software. If this flash-
ing process also fails, flash the initial
software on the ECU and afterwards
retry flashing the desired Software-
version
m
WARNUNG
m
WARNING
Only Software that is suits a specific engine type
is allowed to be flashed on an ECU (see
SB-912 i-002iS). If the set Engine Type set in
the ECU deviates from the hardware configu-
aration of the engine, contact a ROTAX Distribu-
tor immediately.
Step Procedure
11 Switch to “Software Load“-Tab.
12 Select “Browse“ in the “Software Package
Loading“ section.
13 Navigate to the appropriate ECU Soft-
ware file. (ath) and confirm with “Open“.
14 The path to this file and the Software P/N
will be shown in the “Software Package
Loading“ section.
B.U.D.S. Aircraft Maintenance Load“: Software Load“
09966
Step Procedure
15 Select “Load Package“.
16 Consequently a window will open to en-
sure that the user is aware of flashing the
ECU Software. Confirm this window with
“OK“.
17 Wait until the Software flashing process is
finished. The process itsself should take
approximately 1 minute (a status display
will indicate the progress).
m
WARNUNG
m
WARNING
Do not disconnect or power down the ECU du-
ring the Software flashing process.