Biotek Synergy HT, Руководство оператора

Страница: 95 / 240

Absorbance Plate Test
|
73
Synergy HT Operator's Manual
Procedure: Gen5™
To run the Absorbance Plate Test using Gen5:
1. In Gen5, select System|Diagnostics|Test Plates|Run .
2. If prompted, select the desired Test Plate and click OK.
3. When the Absorbance Test Plate Options dialog appears, check Perform
Peak Wavelength Test
if it is not already checked.
4. Highlight the wavelength(s) to be included in this test.
•
Note: You need to select only those wavelengths most appropriate for
your use of the reader.
5. (Optional) Enter any Comments .
6. Click Start Test.
7. Place the Test Plate in the microplate carrier so that well A1 is in the left
rear corner of the carrier (as you are facing the carrier).
8. Click OK to run the test.
9. When the test completes, the results report will appear. Scroll down
through the report; every result should show ‘PASS’. See page 78 for
information on results and troubleshooting tips in the event of failures.
•
A sample test report is shown on pages 76 and 77.
•
Gen5 stores the results in a database; they can be retrieved and printed
at any time. We recommend you print and save the report to document
that the test was performed.